JVC KW-NT1 - Manual (Page 67)

ENGLISH
65
Menu items Selectable settings
Audio
Fader/Balance Fader: Adjust the front and rear speaker output balance.
• F6 to R6; Initial 0
– When using a two-speaker system, set the fader to the centre (0).
Balance: Adjust the left and right speaker output balance.
• L6 to R6; Initial 0
Press [
5/∞/2/3 ] or drag the cursor to adjust.
• To set the fader and balance to the centre (0), press [Centre].
Equalizer Flat/Hard Rock/R&B/Pop/Jazz/Dance/Country/Reggae/Classic/
User1/User2/User3 (
☞ page 64)
Subwoofer/HPF Adjust the subwoofer output level, Cross Over, and High Pass Filter.
Press [Enter] to adjust each setting.
• Level: Adjust the subwoofer output level.
–6 to +8; Initial 0
• Cross Over: Adjust the crossover frequency between the front/rear
speakers and the subwoofer.
80Hz, 120Hz, 150Hz
• High Pass Filter:
On: Select when the subwoofer is connected.
Through: Select when the subwoofer is not connected.
Adaptive Volume When this function is activated, the System automatically increases the
volume level (both for guidance and audio) as the car speeds up.
Off, Min, Mid, Max
Telephone Muting * Muting1, Muting2: Select either one which mutes the sounds while
using the mobile phone.
Off: Cancels.
Amplifier Gain You can change the maximum volume level of this unit.
High: VOL 0 to 20 (for guidance)/VOL 00 to 50 (for audio)
Low: VOL 0 to 15 (for guidance)/VOL 00 to 30 (for audio)
(Select this if the peak power of the speakers is less than 50 W.)
Off: Deactivates the built-in amplifier (VOL 0 to 20 for guidance/VOL 00
to 50 for audio.)
• If you change this setting from <High>/<Off> to <Low> while
the volume level is set higher than the maximum level of <Low>,
the unit automatically lowers the volume level (guidance: VOL 15/
audio: VOL 30).
* The TEL MUTING lead connection is required. (
☞ Installation/Connection Manual)
AV menu items
Cursor
Continued on the next page
Initial: Underlined
EN_KW-NT1[E]3.indb 65 EN_KW-NT1[E]3.indb 65 09.5.29 1:15:08 PM 09.5.29 1:15:08 PM