JVC KW-NT1 - Manual (Page 9)

7
ENGLISH
Installation settings
When you turn on the unit for the first time, the initial
setup screen appears.
~
Turn on the ignition switch.
The power is turned on, and the opening screen is
displayed for about 5 seconds, then the language
selection screen is displayed.
Ÿ
Select the language you want for the
display and the voice guidance.
• You can also select the system language
through <Language>. (
☞ page 67)
!
Display installation settings screen.
• If you select [Skip Installation Settings
(for Store Display)], the System starts in the
navigation demonstration mode for stores.
You need to make the installation settings
next time you turn on the power or detach the
monitor panel (then attach it).
• When selecting [Start Installation
Settings], <Demonstration> is set to
<Off>. (
☞ page 66)
⁄
Adjust the settings.
Country Select the country where you
are now.
Time Zone * 1 Select your residential area for
automatic clock adjustment by
GPS signal.
Summer
time *
1
Select <Auto> if your
residential area is subject to
Summer time.
Reverse
Signal
Polarity *
1
Select the reverse signal polarity
(<Battery> or <GND>)
according to the connection of
your car.
Camera
Input *
2
Select <On> when connecting
the rear view camera to the
CAMERA IN jack.
* 1 * 2 You can also change these settings through
<Settings>. (* 1 :
☞ page 67 /
* 2 :
☞ page 66)
@
¤
Finish the procedure.
Introduction
EN_KW-NT1[E]3.indb 7 EN_KW-NT1[E]3.indb 7 09.5.29 1:13:56 PM 09.5.29 1:13:56 PM