Accusys ExaSAN A08S-PS - Manual (Page 20)

ExaSAN A08S-PS User’s Manual
Installing the Hard Disk Drives
The RAID system is shipped with the disk trays installed in the chassis. Follow
the instructions in this section to install hard disk drives in the disk trays.
To remove the disk tray:
1. Unlock the rear panel door and
pull it open.
2. Push the button on the disk tray
to release the handle, and pull
the disk tray out.
To secure the hard disk drive onto the disk tray:
1. Insert the hard disk drive into the
disk tray, with the connectors
facing outward.
2. Slide the hard disk drive forward
until the connectors align with the
end of the disk tray.
3. Secure the hard disk drive onto
the disk tray with four screws, two
on either side of the disk tray.
20