Accusys ExaSAN A08S-PS - Manual (Page 24)

ExaSAN A08S-PS User’s Manual
Removing the External PCIe x4 Cable
z Put your finger into the ring of
the external PCIe x4 cable
connector and pull gently to
release it.
Do NOT remove the external PCIe x4 cable forcibly in any
other way, as this will damage the cable.
Connecting to a Power Source and Powering On
1. Plug the power cables into
the power socket(s) on the
back of the RAID system,
and connect the other end
to a power source.
2. Press the power switch on
the front of the RAID
system.
Before powering on, make sure the hard disk drives,
controller(s), Re-drive card, external PCIe x4 cable(s),
and power cables are properly installed and connected.
24