Activeforever Ironman IFT2000 Infrared Therapy Inversion Table - Manual (Page 10)

10
ASSEMBLY INSTRUCTIONS
Step 1
Stand up the base of the machine by separating the frames.
Pull the Front and Rear U-Frames (1, 2) as far apart from
each others as possible. Then push down on the middle of
the two Folding Arms (8) until they are fully locked down.
Attach both Front Foot Caps (53) onto the Front Frame (1)
with two Ø16xØ6.5x1.0 Washers (27) and M6x25 Bolts (51).
Attach Left/Right Front Foot Caps (48, 49) onto the bottom of
the Front U-Frame (1) with two M6x20 Phillips Bolts (47) and
two Ø12xØ6.5x1.0 Washers (56).
Attach Left/Right Rear Foot Caps (50, 51) onto the bottom of
the Rear U-Frame (2) with two M6x20 Phillips Bolts (47) and
two Ø12xØ6.5x1.0 Washers (56). Tighten bolts with the Phillips
Screwdriver provided.
Hardware:
․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․
Step 2
Install two Øx27xØ13.5 Nut Caps (42) onto M8Lock Nuts (15).
Slide the Protective Covers (37) on to each side of the base as
shown, and pull down on the covers until the bottom of the covers
are slightly lower than the Folding Arms (8). Use the Velcro straps
on the bottom of the covers to secure the covers to the folding arms.
When the covers are assembled correctly, the folding arms should
be fully covered by the protective covers.
Hardware:
4 Washers (Ø12xØ6.5x1.0) 4 Phillips Bolts (M6x20)
Tool:
Phillips Screwdriver
2 Nut Caps (Ø27xШ13.5)