Activeforever Aeroneb Go - Manual (Page 10)

TO OPERATE BATTERY POWERED CONTROLLER WITH
AN AC/DC ADAPTER
1. Alternatively, you can power the
device by using the AC Adapter
if provided. Plug the AC adapter into a
standard AC electrical outlet, a green
light on the adapter indicates that the
AC adapter is turned on. Plug the AC
cable into the Control Module,
indicated by the Input Symbol (See
Classifications and Markings, pg. 4).
NOTE: The AC/DC Adapter does not charge batteries.
2. Turn on the unit by pressing the "on/off"
button on the Battery Powered
Controller.The green light on the Battery
Powered Controller will light up. Visually
verify that aerosol is coming out of the
mouthpiece or mask to indicate that the
device is functioning properly.
3. Place the mouthpiece between your
teeth, with your lips firmly sealed
around the mouthpiece. If you use an
aerosol mask, place the mask over your
mouth and nose. Breathe in and out
slowly through your mouth until
aerosol formation stops. Do not cover
the ventilation holes during use.
4. Press the "on/off" button on the
Battery Powered Controller again to
turn the nebulizer off.
TO OPERATE WITH AN AC/DC POWERED CONTROLLER
The nebulizer can be powered directly with an AC Powered Controller.
NOTE: Aerosol mask is not provided.
1. Insert the AC Powered Controller cable
connector into the back of the
Nebulizer Unit by sliding the cable
straight up the nebulizer body.
2. Plug the AC Powered Controller into a
standard AC electrical outlet using the
appropriate outlet adapter. The green
light on the AC Powered Controller will
light up.
3. Visually verify that aerosol is coming
out of the mouthpiece or mask to
indicate that the device is functioning
properly.
4. Place the mouthpiece between your
teeth, with your lips firmly sealed
around the mouthpiece. If you use an
aerosol mask, place the mask over your
mouth and nose. Breathe in and out
slowly through your mouth until
aerosol formation stops. Do not cover
the ventilation holes during use.
5. Unplug the AC Powered Controller
from the wall to turn it off. Disconnect
the cable from the Nebulizer Unit by
sliding the cable straight down the
handset, disassemble Nebulizer Unit
and rinse Nebulizer unit Parts after
each use.Wipe dry the Connector end
of the cable after each use. Clean the
nebulizer unit and associated parts
daily. Do NOT remove the retaining ring
under the medication cup.
9 10
AC Adapter Cable