Activeforever Aeroneb Go - Manual (Page 9)

then replace the three “AA” batteries. (2) If the green light only
comes on while depressing the button, immediately replace the
three “AA” batteries.
5. Place the mouthpiece between your
teeth, with your lips firmly sealed
around the mouthpiece. If you use
an aerosol mask, place the mask over
your mouth and nose. Breathe in and
out slowly through your mouth until
aerosol formation stops. Do not
cover ventilation holes.
NOTE: Aerosol mask is not provided.
NOTE: (1) The Battery Powered Controller is designed to shut
off after 16 minutes. If medication still remains in the cup, press
the “on/off” button on the Battery Powered Controller to
continue your treatment. (2) Battery life is dependent upon not
only the number of treatments per day, but also the length of
each treatment. It is recommended that you always have a
spare set of new batteries available to you.
6. Press the "on/off" button on the
Battery Powered Controller again to
turn the nebulizer off. Disconnect
the cable from the Nebulizer Unit by
sliding the cable straight down the
handset, disassemble Nebulizer Unit
and rinse Nebulizer Unit Parts after
each use. Do NOT remove the
retaining ring under the medication
cup. Wipe dry the connector end of
the cable after each use. Clean the
Nebulizer Unit and associated parts
daily.
NOTE: Removal and improper reinsertion of the retaining ring
from the underside of the medication cup may cause the unit
to leak or malfunction.
11 8
CLEANING AND STORING YOUR AERONEB ® GO
TO OPTIMIZE THE PERFORMANCE and life expectancy of your
Aeroneb Go device, we recommend you follow these cleaning
instructions carefully.
AFTER EVERY USE:
Disconnect the power source before you take the nebulizer
apart to rinse it.
1. Rinse the Nebulizer Unit (Medication Cup, Nebulizer Body,
and Mouthpiece or Mask Adapter and Mask) under running
hot tap water after every use.
2. Shake off excess water and you may use device. Keep out of
the reach of children.
3. Make certain that all cleaned parts are completely dry before
you store or use them.
NOTE: Water remaining on the underside of the Aeroneb® Go
generator after cleaning may cause the unit not to work.
Be sure to shake off any excess water prior to use.
DAILY:
Disconnect the power source before you take the nebulizer
apart to clean it.
5. Disconnect the cable from the
Nebulizer Unit by sliding the cable
straight down the handset, disassemble
Nebulizer Unit and rinse Nebulizer Unit
Parts after each use. Do NOT remove
the retaining ring under the medication
cup. Wipe dry the connector end of
the cable after each use. Clean the
Nebulizer Unit and associated parts
daily.