Activeforever Aeroneb Go - Manual (Page 6)

IMPORTANT PARTS
UNIT ASSEMBLY AND USAGE
NOTE: Clean all parts of your Aeroneb ® Go Nebulizer
(as described in this instruction manual) before first use,
after each use, or after extended storage.
PRIOR TO ASSEMBLY:
Check all parts for visible damage. Replace any damaged parts
before you use the Aeroneb
® Go. In the case of missing parts,
malfunction or damage, contact your local Aeroneb ® Go
representative or evo Medical Solutions.
IMPORTANT NOTICE
Before you begin, run the Medication Cup under hot water,
then tap the generator slightly.
Medication Cup Cap
Mouthpiece
Medication Cup
(with OnQ Aerosol
Generator)
Ventilation Holes
Nebulizer Body
5 14
Battery Powered Controller
with detachable power cord
AC/DC Adapter
with attached power cord
AC/DC Controller
with attached power cord
IMPORTANT CAUTION
As with any mechanical device, this product may become
unusable due to an electrical outage, battery depletion, or
mechanical failure. We recommend that you have spare batteries
and have a backup device available to you.
If this product is being used to treat a life threatening condition,
a backup device is necessary.
• In event of loss of electrical power, remove the AC Powered
Controller cable from the Aeroneb ® Go Nebulizer Unit and
operate with the Battery Powered Controller. (refer to page 7).
• Never clean your Nebulizer Unit with solvents, chemicals,
alcohol or abrasive cleaners.
• Do not microwave any parts.
• Do not use brushes, sharp tools or abrasive cloths that could
scratch or damage the surfaces.
• Do not clean parts in a dishwasher.
• Do NOT remove the retaining ring under the medication cup.
NOTE: Removal and improper reinsertion of the retaining ring
from the underside of the medication cup may cause the unit to
leak or malfunction.
• Store your Aeroneb ® Go in the carrying case.
• Do not store the Aeroneb ® Go in a location where it is
exposed to direct sunlight, extreme heat or cold, dust or
water. Store out of reach of children.
• Follow local laws and recycling plans regarding disposal or
recycling of components, batteries and packaging.
• Before storing your Aeroneb ® Go for a long time, remove the
batteries from the Aeroneb ® Go Control Module and store
them separately. If you do not take the batteries out, they may
leak and cause your nebulizer to stop working.