EVS EPSIO Version 1.63 - May 2011 User's Manual - Manual (Page 18)

Issue 1.63.C Epsio Version 1.63 – User’s Manual
EVS Broadcast Equipment – May 2011
12
2.2 CONNECTING EPSIO AND EVS SERVER
2.2.1 S
TARTING THE
EVS S
ERVER
A
PPLICATION
When using Epsio with an EVS server, you need to run a server application:
• with at least 2 recorder channels and 2 player channels
• in a Multicam LSM base configuration.
For more information on starting an EVS application, refer to the EVS Menu
section in the Technical Reference Software manual.
2.2.2 E
PSIO
S
ETTINGS ON
R
EMOTE
P
ANEL
The settings to activate the Epsio mode, and specify the default Epsio tool are
available on page 9.2 of the Setup menu:
S p e c i a l E f f e c t p . 9 . 2
[ F 1 ] P a i n t / T a r g e t O S D M o n i t o r i n g : S D
[ F 2 ] O f f s i d e L i n e : O n
[ F 3 ] E x t e r n a l O f f s i d e : O n
[ F 4 ] I P A d d r e s s : x x x . x x x . x x x . x x x
[ F 5 ] D e f a u l t t o o l : O f f s i d e
[ F 6 ] A u t o M a r k : O f f
[ M e n u ] Q u i t [ C l r + F _ ] D f t [ F 9 ] P g U p [ F 0 ] P g D n
These settings are described below:
Setting Possible
Values
Description
[F2] Offside
Line
On, Off
(default)
Activates the offside line feature, whatever
internal or external.
When the parameter is set to ‘On’, the External
Offside parameter is displayed.
[F3] External
Offside
On, Off
(default)
Enables the control of Epsio from the Remote
Panel.
When the setting is set to ‘Off’, the offside line
feature built in the EVS server is active. The
SHIFT+D key in the Operational menu gives
access to the Epsio menu.
When the setting is set to ‘On’, the Epsio
application is active. The SHIFT+D key in the
Operational menu gives access to the Epsio
menu. The IP Address and Default Tool
parameters are displayed.