EVS EPSIO Version 1.63 - May 2011 User's Manual - Manual (Page 71)

Epsio Version 1.63 – User’s Manual
EVS Broadcast Equipment – May 2011
Issue 1.63.C
65
The director’s PGM and the operator’s PGM are running and pause when it
gets to the beginning of the offside line animation. The pause duration
depends on the Pause Duration setting. The animation is then played.
9. After the animation has been played, you can use the lever or press PLAY to
carry on playing the record train.
10. Press RECORD to go out of the Epsio menu.
If the operator keeps the Graph command active, the graphic will be played when
the clip will go on air.
If the director invalidates the offside line on his PGM, the operator can press A
again to deactivate the Graph command. When the clip will go on air, the offside
sequence will be played out ‘clean’, without the offside line animation.
3.2.4 S
AVING
P
OSITIONS OF
O
FFSIDE
L
INE
A
NIMATIONS
You can save the position of maximum ten offside line animations using the
function keys F1 to F10.
H
OW TO
S
AVE THE
P
OSITION OF AN
O
FFSIDE
L
INE
When you have marked your offside line using the MARK key, you can save its
position by pressing the F_ keys on the Remote Panel.
H
OW TO
R
ECALL THE
P
OSITION OF AN
O
FFSIDE
L
INE
To recall the offside line position you have previously saved under a function key,
you first need to enter the Epsio menu and activate the offside line mode.
Recall the position by pressing the F_ key corresponding to the saved position of
the requested offside line.
Once you have recalled the position, you can press MARK to redefine the offside
line animation at the position you have recalled.