Manhattan 525480 150N Wireless Router - Manual - Manual (Page 12)

12
SYSTEM & NETWORK SETUP
3. Enter “ipconfig,” then press <Enter>. The IP address displays, followed by the
default gateway. In the example below, the IP address of the router is
192.168.2.1.
NOTE: If the IP address of the gateway is not displayed, or if the address begins
with 169, recheck the network connection between your computer and the router,
and re-check each step of the network setup procedure.
4. Once your computer has obtained an IP address from the router, open your Web
browser and enter the IP address of the router into the address bar. When the
login window displays (see 2.2 above), enter the username (“admin”) and the
password (“1234”). Press “OK” to display the router’s Web management interface.
NOTE: If you can’t see the Web management interface and you’re being prompted
to enter the user name and password again, it means you didn’t enter the correct
username and password. Re-type the username and password. If you’re certain
that the username and password are correct, refer to 4-2 Troubleshooting to
perform a factory reset to set the password back to the default value.
TIP: This page (see 2.3 Quick Setup below) shows the four primary setting
categories: QuickSetup, General Setup, Status and Tools. You can jump to
another menu category directly by clicking the link at the top-right of each screen.