Manhattan 525480 150N Wireless Router - Manual - Manual (Page 37)

37
SYSTEM & NETWORK SETUP
“WPA (TKIP),” “WPA2 (AES)” or “WPA2 Mixed” — make sure your wireless
clients support it.
RADIUS Server IP address — Enter the IP address of the RADIUS server.
RADIUS Server Port — Enter the port number of the RADIUS server.
RADIUS Server Password — Enter the password of the RADIUS server.
2.7.4 Wireless Access Control
This function helps to prevent unauthorized users from connecting to your router:
Only those wireless devices that have the MAC address you assign here can gain
access. The MAC address is a unique hardware identification number that every
network adapter carries. You can use this function in combination with data
encryption (WPA, WPA2 or WEP) to create an additional layer of security for your
wireless network.
Up to 20 MAC addresses can be assigned using this function. Click the “Wireless”
menu on the left of the Web management interface, then click “Access Control.”
NOTE: As explained below, all allowed MAC address will display in the MAC
Address Filtering table.
Delete — To delete a specific MAC address entry, check the “Select” box of the
MAC address you want to delete, then click “Delete Selected.” (You can select
more than one MAC address at a time.)
Delete All — Click to delete all MAC addresses listed.
Enable Access Control — Select to enforce MAC address filtering. The router will
not filter the MAC addresses of wireless clients if this is left unchecked.
MAC Address — Enter the MAC addresses of your wireless devices here without
special characters. If the MAC address label of your wireless device indicates