SUUNTO E203 - Manual (Page 15)

12
13. PRESS the Center button to accept the choice and move to next menu setting the
units of measurements. Alternatively, PRESS and HOLD the Center button for 2
seconds to accept all changes made and return to the TIME mode.
Note: It is not necessary to set or change each menu item. You can PRESS the Cen-
ter button until the desired menu item flashes and then make adjustments. To accept
the desired value, PRESS and HOLD the Center button for 2 seconds thereby exiting
the setup mode and returning to the main feature you were in.
Note: If no buttons are pushed within one minute after entering the setup, the device
automatically exits the setup mode and the values displayed at this time will remain
as the current settings.
2.2. SETTING UNITS OF MEASUREMENT
In this mode, the user will be setting the following units of measure: temperature,
vertical ascent/descent rate, atmospheric pressure, and altitude.
To set or change the units of measurement:
In the TIME mode:
1. PRESS and HOLD the Center button in for 2 seconds.
2. Then PRESS the Center button (6 times) until the text "Set Unit" appears in Fields
3 and 4. Located above Field 4, either the text "m" or "ft" begins to flash.
3. PRESS either the [+] button or the [-] button to toggle between meters ("m") or feet
("ft") until the desired unit of measure is displayed.
4. PRESS the Center button to accept the choice and move to the next menu item.
Located above Field 4, the text "hPa" or "inHg" will begin to flash.
5. PRESS either the [+] button or the [-] button to toggle between "hPa" or "inHg" until
the desired unit of measure is displayed.