TROY Group MICR_IRD 9000 1UP MICR Printing Solutions User’s Guide - Manual (Page 103)

Section 6 Using the Printer Control Panel
MICR Solutions User’s Guide -- Document #50-70341-001 Rev. F
6-5
Using the
Exact
Positioning
Technology
If the MICR line on your checks does not meet the ANSI X/9B specification for MICR line placement, use this
feature to make small vertical and/or horizontal positioning adjustments to the MICR line and/or page image.
Use the TROY MICR Document Template (54-17373-001) to verify the correct placement of the MICR line on
your checks after performing an adjustment (refer to
Section 3 – MICR Quality Control in the TROY MICR
Basics Handbook for instructions on using the TROY MICR Document Template). If adjustments are made
simultaneously to the MICR line and the page image positions using positive numbers, then the sum of the two
numbers will be used as the offset value for the MICR line.
NOTE: The MICR line adjustments are preset at the factory. TROY recommends that you do not alter these
settings unless your bank of deposit notifies you of MICR line positioning errors on your deposited checks.
T
O EVALUATE THE PLACEMENT OF THE MICR LINE ON YOUR PRINTED CHECKS :
1. Print one page of test checks to use for evaluating the positioning of the E-13B MICR printing at the bottom
of each check (see the example below).