TROY Group MICR_IRD 9000 1UP MICR Printing Solutions User’s Guide - Manual (Page 16)

Section 2 Understanding TROY’s Features
MICR Solutions User’s Guide -- Document #50-70341-001 Rev. F
2-3
MICR Mode TROY MICR solutions can be set to a default MICR mode of either ENABLED or DISABLED to suit the security
requirements of your MICR printing environment. MICR mode must be enabled to allow the printing of MICR
checks and documents. The following table describes the operational characteristics of the MICR mode enabled
and disabled states. Refer to
page 2-7 in this section for detailed information.
MICR Mode Operational Characteristics
MICR ENABLED A TROY MICR font call will cause the user login, keylock switch, and MICR toner cartridge statuses to
be checked for MICR printing availability. If the correct conditions exist (authorized user login, keylock
switch set to appropriate setting, and a MICR toner cartridge installed), the MICR print job will proceed
normally. Sending a MICR
DISABLE command will change the MICR ENABLED mode to MICR DISABLED .
MICR DISABLED A TROY MICR font call will cause the TROY MICR font to automatically be substituted for an alternate
font using the same font data. The current status of the keylock switch or presence of a MICR toner
cartridge will not affect the MICR printing availability. MICR cannot be printed with MICR mode
DISABLED . Sending a MICR ENABLE command will change the MICR DISABLED mode to MICR ENABLED .
NOTE: The printer keylock is present on MICR Secure and MICR / IRD Secure EX series printers only.
MICR toner cartridge sensing is present on MICR EX, MICR Secure, and MICR / IRD Secure EX series printers only.