Veris Technologies Precision Rate Controller - Operation Manual - Manual (Page 7)

Pub.# OM17-PRC
2-2
Figure 7. This is the first window that appears in Calibration mode. Press
Function key to accept, or Up key to change to metric settings.
Figure 8. Enter implement width here using Up/Down arrow keys. Press
Function key to advance to next window.
Figure 9. Enter number of rows here using Up/Down arrow keys. Press Function
key to advance to next window.
Figure 10. Enter your planned planting speed using Up/Down arrow keys.
Calibration mode will not accept a speed higher than 10 mph. Press Function
key to advance to next window.
Figure 11. Enter the number of seeds you want to count. For singulated
metering, at least 100 seeds should be selected. Press Function key to advance
to next window.