Veris Technologies Precision Rate Controller - Operation Manual - Manual (Page 9)

Pub.# OM17-PRC
2-4
Figure 16. While the drive is rotating, the display window shows the time
remaining and the “Out” rate. CONTINUE TO MONITOR DRIVE AREA DURING
DRIVE ROTATION. PRESS THE ENGAGE KEY (OR OFF KEY) TO STOP
DRIVE DURING CALIBRATION
Figure 17. After Calibration meter rotation has ended, the screen above left will
appear. Enter the actual amount metered using the Up/Down arrow keys as
shown in Figure 18, above right. Press Function key to advance to next window.
Figure 19. A New calibration number is suggested, along with the Old calibration
number. Press Function key to advance to window shown in Figure 20.
Figure 20. If you wish to keep the Old number, perhaps to re-run the calibration
procedure, press the Down arrow key. If you want to accept the New calibration
number, press the Up arrow key.