VEGA VEGAPULS 63 (≥ 2.0.0 - ≤ 3.8) 4 … 20 mA_HART - two-wire - Manual (Page 6)

D uring the entire duration of use, the user is obliged to determine the
compliance of the necessary occupational safety measures with the
current valid rules and regulations and also take note of new
regulations.
2 .5 Safety label on the instrument
T he safety approval markings and safety tips on the device must be
observed.
2 .6 CE conformity
T his device fulfills the legal requirements of the applicable EC
guidelines. By attaching the CE mark, VEGA provides a confirmation
of successful testing. You can find the CE conformity declaration in the
download area of "www.vega.com".
2 .7 Fulfillment of NAMUR recommendations
T he device fulfills the requirements of the applicable NAMUR
recommendations.
2 .8 FCC/IC conformity (only for USA/Canada)
VEGAPULS sensors with all antenna versions are FCC/IC approved.
M odifications not expressly approved by VEGA will lead to expiry of
the operating licence according to FCC/IC.
VEGAPULS 63 is in conformity with part 15 of the FCC directives and
fulfills the RSS-210 regulations. Note the corresponding regulations for
operation:
l T he instrument must not cause any interfering emissions
l T he device must be insensitive to interfering immissions, including
those that may cause undesirable operating conditions
A ccording to chapter "Dimensions" of this operating instructions
manual, the instrument is designed for operation with an antenna with
a max. amplification of 33 dB. The instrument must not be operated
with antennas not listed therein or those having an amplification of
more than 33 dB. The required antenna impedance is 50 Ω.
2 .9 Safety instructions for Ex areas
P
lease note the Ex-specific safety information for installation and
operation in Ex areas. These safety instructions are part of the
operating instructions manual and come with the Ex-approved
instruments.
6 VEGAPULS 63 • 4 … 20 mA/HART - two-wire
2 F or your safety
28436
-EN
-120530