VEGA VEGADIF 34 … 51 - Manual (Page 25)

VEGADIF 34 … 51 25
20094-EN-030731
Min.
Max.
Atmospheric pressure on the minus
side of the transmitter
P
atm
Mounting
Mounting on horizontal pipe
Wall mounting
Use the following mounting kit material:
- mounting bracket
- four hexagon screws
Provide the following material:
- four screws with suitable plugs
Note the following procedure:
1 Screw the mounting bracket to the wall by
using the screws with the suitable plugs.
2 Screw the transmitter to the bracket (the
screws with plain washers pass via the
holes of the bracket into the thread).
Mounting with valve block 1)
The valve block is fastened by pipe or wall
mounting as described above.
Procedure:
1 Fasten bracket to a pipe or wall.
2 Screw the valve block to the mounting
bracket with two hexagon screws and plain
washers.
The transmitter is normally flanged to the valve
block just before setting up the measurement
loop.
2.3.2 VEGADIF 44 and 45
The following instructions are for VEGADIF 44,
however, they are also applicable to VEGADIF
45.
Open vessel
The minus side of the transmitter is open to
atmospheric pressure. Therefore the open
process connection of the minus side should
point downwards.
1) not with VEGADIF 51