VEGA VEGAMET 407 Z - Manual (Page 10)

10 VEGAMET 407 Z
Operating surface
Operation
Set-up
- mounting socket
- connect capacitive measuring electrode or
pressure transmitter with the mounting socket
terminal 1 and 2, see page 8
- adjust the current output, see page 8
- check the connection and type plate
push VEGAMET 407 Z onto mounting socket and
fasten
- switch on power supply
LED (green) voltage supply lights
LED (red) fault signal lights
fault monitoring relay remains de-energized
software stage is indicated
- after approx. 2 sec.
fault-monitoring LED extinguishes
fault-monitoring relay is energized
a meaningless figure is displayed
- program empty and full adjustment, see
page 11
- if necessary, program
integration time, see page 12
password, see page 13
(procedure)
MOD
MOD
+
-
MOD
STO
SIM
0.0
%
0 00.0 001. 6
z.B.
% %
The VEGAMET 407 Z has 3 modes which can be
obtained by scrolling the MOD-button:
Mode: 1. Measurement
2. Mode range
3. Parameter adjustment
Note that if no pushbutton is operated, after a
period of 60 minutes the display resets to level
measurement.
1. Measurement
2. Mode range
3. Parameter
adjustment
Measurement:
Level: %
Enquiry of the mode
numbers in the MODE-
FIELD. The parameters
of the enquired modes
can be indicated or
modified in mode 3.
Programming of the
parameters in the
PARAMETER FIELD.
The parameter of the
respectively selected
mode can be modified
and stored with the STO-
button. If no change
should be realized, push
the MOD-button. In both
cases reset to mode 1.
Cursor positi on
Cursor position
Value (increase)
Value (decrease)
Storage