VEGA VEGASWING 51 - contactless electronic switch - Manual (Page 21)

7 Maintenance and fault rectification
7 .1 Maintenance
If the instrument is used properly, no special maintenance is required
in normal operation.
7 .2 Remove interferences
The operator of the system is responsible for taking suitable measures
to rectify faults.
VEGASWING 51 offers maximum reliability. Nevertheless, faults can
occur during operation. These may be caused by the following, e.g.:
l Sensor
l Process
l Voltage supply
l Signal processing
The first measure to be taken is to check the output signal. In many
cases, the causes can be determined this way and the faults rectified.
Should these measures not be successful, please call in urgent cases
the VEGA service hotline under the phone no. +49 1805 858550.
The hotline is available to you 7 days a week round-the-clock. Since
we offer this service world-wide, the support is only available in the
English language. The service is free of charge, only the standard
telephone costs will be charged.
Error Cause Removal
Control lamps off Voltage supply
interrupted. Check the voltage supply and the
cable connection
Electronics mo-
dule defective Exchange the electronics module
Signal lamp fla-
shes red There was no
load connected
when connecting
to power supply Connect the instrument correctly.
Make sure that the sensor cannot be
operated without load.
Error on the tu-
ning fork Check if the tuning fork is damage or
extremely corroded
Buildup on the
vibrating element Check the vibrating element and the
sensor if there is buildup and remove it
Reaction when malfunc-
tions occur
Failure reasons
Fault rectification
24 hour service hotline
Checking the switching
signal
VEGASWING 51 • - contactless electronic switch 21
7 Maintenance and fault rectification
30212
-
EN
-111006