VEGA VEGALOG 571 CPU and carrier - Manual (Page 11)

l
With increased ambient temperatures
4.3 Mount female multipoint connectors
The carrier BGT LOG 571 is supplied completely assembled.
To mount the individual module cards, modules must be
provided in the requested positions. A module consists of:
l
a female multipoint connector according to DIN 41612,
series F, 48-pole
l
two fixing screws
l
two coded pins
l
two guide rails
The female multipoint connector is available with the following
connections:
l
Wire-Wrap standard connection 1.0x1.0 mm
l
Plug connection 2.8x0.8 mm
l
Termi-Point standard connection 1.6x0.8 mm
l
Soldering connection
l
Screw terminals 0.5 mm²
If the VEGALOG 571 is supplied completely with carrier and
peripheral cards, the modules are completely mounted and
voltage supply for the individual cards is already looped. In
case of part or supplementary orders, the female multipoint
connectors must be mounted in the requested position by
means of the attached screws. Also the card guides must be
plugged in the corresponding positions. To complete the
setup, connect the 24 V supply voltage, the terminal assign-
ment is stated in chapter "Connecting to power supply".
Tip:
Determine the position of the individual cards now and plug in
the coded pins as described in chapter "Coding".
4.4 Coding
A mechanical coding system avoids later interchanging of the
various module cards in the carrier.
The coding system consists of:
l
two coded pins in the female multipoint connector
l
two holes in the male multipoint connector of the respective
component
The coded pins are attached to the module.
VEGALOG 571 - CPU and carrier 11
Mounting
31947
-EN
-060606