VEGA VEGALOG 571 CPU and carrier User Manual
Page 28
l
Connection 0/4 … 20 mA instrument
l
Arithmetik
l
Temperature measurement
l
Universal
Depending on the selected application, a suitable sensor or
the measuring principle and probable options will be enquired.
The designation of the measurement loop with an individual
name is made at the end of the assistant setup.
Fig. 10: Creating/modifying measurement loop
After creating the measurement loop you can carry out the
adjustment, select a linearization or assign and configure relay/
current outputs.
When using the EP card, the project includes also all
connected PA sensors. Via the same cable connection you
have also access to these sensors to show e.g. the echo curve
or carry out a false echo memory. With analogue 4 … 20 mA
instruments, however, this direct access is not possible. In this
case, each sensor must be connected individually, e.g. via a
VEGACONNECT.
Sensor parameter adjustment
Set up
28
VEGALOG 571 - CPU and carrier
31947
-EN
-060606