VEGA PLICSRADIO T61 Wireless emitting unit - Manual (Page 15)

15
5 Connecting to power supply
PLICSRADIO T61 • Wireless emitting unit (single channel)
32865-EN-130322
3
2
1
Fig. 7: Removing the mounting plate on the housing socket
1 Hexagon screws
2 Wall mounting plate
3 Cable gland
3. Loop the connection cable through the cable entry on the housing
base
Tip:
Take note when inserting the cable that after connection, the housing
must be turned again by 180° to screw it securely to the mounting
plate, i.e. bring the instrument into its the final position.
4. Connect the wire ends as described in chapter "Connection plan".
Take note of the polarity.
5. Connect the screen to the internal ground terminal, connect the
outer ground terminal above on the housing to potential equalisa-
tion
6. Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
7. Attach the mounting plate again and tighten the screws
5.3 Connection steps voltage supply
Proceed as follows:
1. Unscrew the housing cover
2. If a display and adjustment module is installed, remove it by turn-
ing it slightly to the left.
3. Remove the terminal cover by loosening the fixing screw