VEGA PROTRAC series 30 Electronics module User Manual
Page 14
Advertising
14
4 Mounting
Electronics module • PROTRAC series 30
40104-EN-130916
Fig. 10: Use the old screws - to do this, remove the holding screws from the old
electronics module
7 Holding screws
14. Insert the four holding screws (7) into the new electronics module
(2)
15. Check if all parts are dry, clean and dust-free.
16. Open the attached tube of special grease (10).
17. Apply special grease (10) to one side of the new optical pad (4).
See the following illustration.
Fig. 11: Apply special grease to one side of the optical pad
4 Optical Pad
10 Special grease
18. Use the edge of the plastic spatula (11) to skim the surface of the
optical pad (4) so that only a wafer-thin grease film remains. See
the following illustration.
Advertising