VEGA PROTRAC series 30 Electronics module - Manual (Page 7)

7
4 Mounting
Electronics module • PROTRAC series 30
40104-EN-130916
4 Mounting
4.1 General instructions
The new electronics module must be loaded with the order and fac-
tory data of the sensor. These are the options:
•
At the factory by VEGA
•
Or on site by the user
Information:
When loading on site, the order data must first be downloaded from
the Internet (see "Setup").
In both cases, the sensor serial number is necessary. The serial num-
bers are stated on the type label of the instrument, inside the housing
or on the delivery note.
Caution:
The order data and factory data contain important presettings for the
sensor. Reliable operation and correct measurement are not possible
without these data.
Warning:
Switch off voltage supply before starting the mounting procedure. The
replacement electronics must only be mounted in idle condition.
Non-observance will damage the electronics!
The safety-relevant data for explosion protection of the electronics
module supplied later can deviate from the data of the previously
installed electronics module. If the electronics module supplied later
is installed in a certified, explosion-protected sensor, it is absolutely
necessary to observe the instrument "Safety instructions" attached to
the supplied electronics module! The attached label must be applied
on the sensor housing.
4.2 Mounting preparations
The electronics modules are mounted in the electronics compartment
and adapted to the respective sensor. First of all check by means of
the following lists if you are using a suitable electronics module.
FIBERTRAC, SOLITRAC, POINTRAC, WEIGHTRAC
•
PT30E.SV for version 4 … 20 mA/HART (four-wire)
•
PT30E.SS for version 4 … 20 mA/HART with SIL qualification
•
PT30E.SP for version Foundation Fieldbus and Profibus PA
MINITRAC
•
PT30E.MV for version 4 … 20 mA/HART (four-wire)
•
PT30E.MS for version 4 … 20 mA/HART with SIL qualification
•
PT30E.MP for version Foundation Fieldbus and Profibus PA
If you have ordered an electronics module with pre-configured serial
number, then the serial number of your sensor is already entered in
the software of the electronics module.
See also chapter "Setup".
Sensor serial number
Assignment
Order with pre-configured
serial number