VEGA VEGAPULS 61 (≥ 2.0.0 - ≥ 4.0.0) Foundation Fieldbus Approval according to LPR radio standard - Manual (Page 28)

9 Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
10 Screw the housing cover back on
The electrical connection is finished.
Information:
The terminal block is pluggable and can be removed from the
electronics. To do this, lift the terminal block with a small screwdriver
and pull it out. When inserting the terminal block again, you should
hear it snap in.
5 .3 Wiring plan, single chamber housing
1 2 ( ) (-)
1
5
0
1
0
1
+ 6 7 8
Bus
2
3
4
5
Fig. 21: Electronics and connection compartment, single chamber housing
1 Voltage supply, signal output
2 Contact pins for the indicating and adjustment module or interface adapter
3 Simulation switch ("1" = mode for simulation release)
4 For external indicating and adjustment unit
5 Ground terminal for connection of the cable screen
Electronics and connec-
tion compartment
28 VEGAPULS 61 • Approval according to LPR radio standard
5 Connecting to the bus system
41716
-EN
-120301