VEGA VEGAPULS 63 (≥ 2.0.0 - ≥ 4.0.0) Modbus and Levelmaster protocol - Manual (Page 64)

64
12 Supplement
VEGAPULS 63 • Modbus and Levelmaster protocol
41364-EN-130228
Parameters for the bus communication
The VEGAPULS 63 is preset with the default values:
Parameter Configurable Values Default Value
Baud Rate 1200, 2400, 4800, 9600, 19200 9600
Start Bits 1 1
Data Bits 7, 8 8
Parity None, Odd, Even None
Stop Bits 1, 2 1
Address range Modbus 1 … 255 246
Start bits and data bits cannot be modified.
General configuration of the host
The data exchange with status and variables between field device and host is carried out via
register. For this, a configuration in the host is required. Floating point numbers with short prevision
(4 bytes) according to IEEE 754 are transmitted with individually selectable order of the data bytes
(byte transmission order). This "Byte transmission order" is determined in the parameter "Format
Code". Hence the RTU knows the registers of the VEGAPULS 63 which must be contacted for the
variables and status information.
Format Code Byte transmission order
0 ABCD
1 CDAB
2 DCBA
3 BADC
12.3 Modbus register
Holding Register
The Holding registers consist of 16 bit. They can be read and written. Before each command, the
address (1 byte), after each command, a CRC (2 byte) is sent.
Register Name Register Num-
ber
Type Configurable
Values
Default Value Unit
Address 200 Word 1 … 255 246 -
Baud Rate 201 Word 1200, 2400,
4800, 9600,
19200
9600 -
Parity 202 Word 0 = None, 1 =
Odd, 2 = Even
0 -
Stopbits 203 Word 1 = None, 2 =
Two
1 -
Delay Time 206 Word 10 … 250 50 ms
Byte Oder (Float-
ing point format)
3000 Word 0, 1, 2, 3 0 -