VEGA VEGAPULS 62 (≥ 2.0.0 - ≥ 4.0.0) Modbus and Levelmaster protocol User Manual
Operating instructions, Vegapuls 62
Advertising
Table of contents
Document Outline
- Quick start
- 1 About this document
- 2 For your safety
- 3 Product description
- 4 Mounting
- 5 Connecting to power supply and bus system
- 6 Set up the sensor with the indicating and adjustment module
- 7 Setting up sensor and Modbus interface with PACTware
- 8 Diagnosis, Asset Management and service
- 8.4 Measurement error with constant level
- 8.4 Measurement error during filling
- 8.4 Measurement error during emptying
- 9 Dismounting
- 10 Supplement
- 10.2 Bus description
- 10.2 Bus architecture
- 10.2 Protocol description
- 10.2 Parameters for the bus communication
- 10.2 General configuration of the host
- 10.3 Holding Register
- 10.3 Input register
- 10.4 FC3 Read Holding Register
- 10.4 FC4 Read Input Register
- 10.4 FC6 Write Single Register
- 10.4 FC8 Diagnostics
- 10.4 FC16 Write Multiple Register
- 10.4 FC17 Report Slave ID
- 10.4 FC43 Sub 14, Read Device Identification
- 10.5 Parameters for the bus communication
- 10.5 Report Level (and Temperature)
- 10.5 Report Unit Number
- 10.5 Assign Unit Number
- 10.5 Set number of Floats
- 10.5 Set Baud Rate
- 10.5 Set Receive to Transmit Delay
- 10.5 Report Number of Floats
- 10.5 Report Receive to Transmit Delay
- 10.5 Error codes
- 10.6 Fisher ROC 809
- 10.6 ABB Total Flow
- 10.6 Thermo Electron Autopilot
- 10.6 Bristol ControlWave Micro
- 10.6 ScadaPack