VEGA MoRoS Modem - ISDN 1.3 - Manual (Page 23)

MoRoS Modem - ISDN 1.3 Mounting
23
9 Mounting
This chapter describes how to mount the MoRoS Modem - ISDN 1.3 to a DIN rail,
connect it to the power supply and disassemble it again.
Danger!
Exposed electrical components!
Risk of death through electric shock hazard!
Prior to the installation, switch the power of the cabinet
off and secure it against being switched on again.
Danger!
Moisture und liquids from the environment may seep
into the interior of the MoRoS Modem - ISDN 1.3.
Risk of death through shock hazard when touching it!
The MoRoS Modem - ISDN 1.3 may not be used in wet or
damp environments, or in or very close to water. Install
the device at a dry location, protected from water spray.
Switch the power supply off before you do any work on a
device which may have been in contact with moisture.
Note
The device could be destroyed if the wrong power supply
is used.
If the MoRoS Modem - ISDN 1.3 is used with a power
supply which has a larger voltage than the allowed op-
erational voltage of the MoRoS Modem - ISDN 1.3, the
device is destroyed.
Make sure that you use the suitable power supply. The
chapter "Technical Data" has the information about the
correct voltage range for the MoRoS Modem - ISDN 1.3.