VEGA MoRoS Modem - ISDN 1.3 - Manual (Page 60)

Functions MoRoS Modem - ISDN 1.3
60
12.11.6 Updating the Firmware of the MoRoS Modem - ISDN 1.3
You can update the firmware of the {{PRODUKTBEZEICHNUNG}}}. The firmware is a com-
bination of operating system and programs, in which the functions of the {{PRO-
DUKTBEZEICHNUNG}}} are implemented. To update the firmware, you will need two files
with a new firmware, which you may receive from your sales partner, or from IN-
SYS MICROELECTRONICS.
Note
Function loss due to faulty update!
During a connection termination during the update and
a following restart, the MoRoS Modem - ISDN 1.3 may
loose its function.
As long as the red LED at the MoRoS Modem - ISDN 1.3
lights up, you are not permitted to perform any actions
at the web interface, you should not pull the power plug
and you should not perform a reset.
After a failed update, do not restart the MoRoS Modem -
ISDN 1.3, but call the INSYS MICROELECTRICS support.
Note
Loss of availability!
Through a firmware update, your MoRoS Modem - ISDN
1.3 may use its earlier configuration. Your MoRoS Mo-
dem - ISDN 1.3 can then only be accessed from the local
network via its standard IP address 192.168.1.1.
Perform critical updates only locally, read the file "Re-
adMe.txt" that comes with the firmware, or contact the
INSYS MICROELECTRONICS support.
Complete update of the MoRoS Modem - ISDN 1.3 firmware
The following steps must be performed to update the firmware of a MoRoS
Modem - ISDN 1.3.
You have access to the web interface.
If you access the web interface of the MoRoS Modem - ISDN 1.3 via a dial-
up connection, the connection must be maintained long enough to per-
form the uploads. The option "Maximum connection time" should be set to
"0" for the update, also for the "Idle time".
You have ensured that the power supply of the MoRoS Modem - ISDN 1.3
can not be switched off during the update procedure.
You have both firmware files; one file with the name "ulmage" and a sec-
ond one with the name "uRamDisk". The files can be found on the PC from
which you want to perform the update.