VEGA MoRoS Modem - ISDN 1.3 - Manual (Page 24)

Mounting MoRoS Modem - ISDN 1.3
24
Mount the device to the DIN rail
Instructions on how to mount the MoRoS Modem - ISDN 1.3 to a DIN rail:
1. Position the device at the DIN rail as seen in the following diagram. There
are two snap-in hooks at the outer edge of the DIN rail groove of the MoRoS
Modem - ISDN 1.3.
Hook them into place behind the upper edge of the DIN rail when connecting
the device.
2. Lift the MoRoS Modem - ISDN 1.3 perpendicular to the DIN rail until the plas-
tic spring of the third, flexible snap-in hook engages in the DIN rail.
The MoRoS Modem - ISDN 1.3 is now completely mounted.
Connecting the power supply
The device has already been mounted to the DIN rail.
The power supply is connected and switched off.
1. Connect the ground lead of the power supply to the terminal "GND".
2. Connect the plus pole of the power supply to the terminal for the power
supply.