VEGA MoRoS Modem - ISDN 1.3 - Manual (Page 27)

MoRoS Modem - ISDN 1.3 Initial Operation
27
10 Initial Operation
This chapter describes how to activate the MoRoS Modem - ISDN 1.3, i.e. how to
connect the MoRoS Modem - ISDN 1.3 to a PC, and how to prepare it for the con-
figuration.
Connect the MoRoS Modem - ISDN 1.3 to a phone network and a PC.
How to connect the MoRoS Modem - ISDN 1.3 to the ISDN or phone con-
nection and with a network cable to the PC, using the included phone cable
/ ISDN cable.
The power supply of the MoRoS Modem - ISDN 1.3 is switched off.
You will need a Cat. 5 network patch cable.
You will need a network card at the PC.
You will need the included phone or ISDN cable.
1. Locate the RJ45 jack of the network card at the PC.
2. Make sure not to use the ISDN jack, but the jack of the network card, which
you want to use to configure the MoRoS Modem - ISDN 1.3.
3. Plug one end of the network cable into the RJ45 jack of the PC network card,
and the other end into a network jack at the MoRoS Modem - ISDN 1.3
switch.
4. Connect the phone or ISDN cable to the RJ 45 line jack at the MoRoS Modem
- ISDN 1.3.
5. Connect the phone cable with the TAE outlet of your phone connection, or
connect the ISDN cable with the RJ 45 jack at the ISDN S0 bus.
MoRoS Modem - ISDN 1.3 configuration
The MoRoS Modem - ISDN 1.3 is connected to the PC.
The power supply of the MoRoS Modem - ISDN 1.3 is switched on.
You have the required access rights to change the IP address of the network
card to which the MoRoS Modem - ISDN 1.3 is connected.
1. Change the IP address of the network card to which the MoRoS Modem -
ISDN 1.3 is connected to an address which starts with 192.168.1.
As an alternative, you may also configure your network card to "Automatic
address allocation". The integrated DHCP server of the MoRoS Modem - ISDN
1.3 will then allocate an address from the according address range to your
network card.