Velleman VDPC148 - Manual (Page 10)

VDPC148 VELLEMAN 10
• The display now shows CH1, indicating that the device is in the MIDI-IN mode.
• Press the desired flash button (1 – 16) to assign this MIDI channel to this DMX channel.
• Hold the RECORD button.
• Press the REC EXIT button to leave this mode.
MIDI-OUT MODE
• Hold the RECORD button.
• Press flash button 2 three times in PRESET A.
• Release the RECORD button.
• The display now shows CH0, indicating that the device is in the MIDI-OUT mode.
• Press the desired flash button (1 – 16) to assign this MIDI channel to this DMX channel.
• Hold the RECORD button.
• Press the REC EXIT button to leave this mode.
RECEIVING A FILE
• Hold the RECORD button.
• Press flash button 3 three times in PRESET A.
• Release the RECORD button.
• The display now shows IN, indicating that the device is ready to receive a file.
• All other operations will be disabled during the reception of the file. The reception will stop automatically at the
end of the file or when mistakes occur.
SENDING A FILE
• Hold the RECORD button.
• Press flash button 4 three times in PRESET A.
• Release the RECORD button.
• The display now shows OUT, indicating that the device is ready to send a file.
• All other operations will be disabled during the reception of the file. The transmission will stop automatically at the
end of the file or if an error occurs.
e) Main functions
REVERSE THE DIRECTION OF THE SCENE
1) To reverse the direction of all scenes, press the ALL REV button. All scenes can change directions.
2) To reverse the chase direction of all programs with speed control; press the chase rev. button.
3) To reverse the chase direction of all programs with standard beat, press the beat rev. button.
4) The reverse the chase direction of any program, press and hold the rec. button, then press the flash button
corresponding to the desired program and release together.
FADE TIME
The amount of time it takes for a dimmer to go from zero to maximum output and vice versa.
The fade time is adjusted through the fade time slider. The fade time varies between instant to 10 minutes.
TAP SYNC BUTTON
The tap button is used to set and synchronise the chase rate (the rate at which all scenes will sequence) by pressing
the button several times. The chase rate will synchronise to the time of the last two laps.
The LED above the step button will flash at the new chase rate. The chase rate can be set any time whether or not a
program is running.
Tap sync will override any previous setting of the speed slider control until the slider is moved again.
When setting a standard beat, the tap sync button has the same function as the speed control slider.