Velleman VDPC148 - Manual (Page 11)

VDPC148 VELLEMAN 11
MASTER SLIDER
The master slider control provides proportional level control over all channels and scenes with the exception of the
flash buttons.
Whenever the master slider control is at its minimum, all stage outputs will be at zero except for those resulting from
a flash button or FULL ON button.
If the master is at 50% all outputs will be at only 50% of the current channel or scene setting except for those
resulting from a flash Button or FULL ON button.
If the master is at its maximum, all outputs will follow the unit setting.
Master A always controls channel outputs. Master B controls a program or a scene except in double press mode.
SINGLE MODE
1) All programs will run in sequential order starting according to the program number.
2) The segment display will show the running program number.
3) All programs will be controlled by the same speed slider.
4) Press the MODE SELECT BUTTON and select “CHNS◄►SCENES”
5) Press the PARK BUTTON to select SINGLE CHASE MODE. A red LED will indicate this selection.
MIX MODE
1) Will run all programs synchronously.
2) All programs can be controlled by the same SLIDER SPEED or each program speed can be controlled
individually.
(see speed setting).
3) Press the MODE SELECT BUTTON and select “CHNS◄►SCENES”.
4) Press the PARK BUTTON to select the MIX CHASE MODE. A yellow LED will indicate this selection.
DIMMER DISPLAY
1) The 3-digit segment display is used to display the intensity percentage or absolute DMX value.
2) To change between percentage and absolute value: press and hold the shift button, while holding down the shift
button press the 5 or 0-255 button to switch between percentage and absolute values.
3) If the segment display shows, for example, “076” it indicates a percentage value of 76%. If the segment display
shows “0.76, it indicates a DMX value of 76.
BLIND AND HOME
1) The blind function takes channels temporally out of a chase when the chase is running and gives you manual
control over the channel.
2) Press and hold the blind button and press the relative flash button you want to temporarily take out of the chase.
3) To return to normal chase again press and hold the home button and push the flash button you want to return to
normal chase.
5. Technical specifications
Power input DC 12-18V 50mA Min.
DMX out 3-pin male XLR socket
MIDI in/out/thru 5-pin DIN socket
Dimensions 710 x 266 x 90mm
Weight 6.3kg
The information in this manual is subject to change without prior notice.