Velleman VDPC148 - Manual (Page 9)

VDPC148 VELLEMAN 9
c) Running
RUNNING CHASE PROGRAMS
1) Press the mode select button to select CHNS◄►SCENES mode indicated by the LED.
2) Press the page button to select the correct page on which the program you wish to run is located.
3) Push the master slider B to its maximum position (fully down).
4) Move the desired channel slider (25-48) to its maximum position to trigger the program; the program will fade in
depending on the current fade time.
RUNNING A PROGRAM TO AUDIO
1) Use the built-in microphone or plug the audio source into the RCA audio jack.
2) Select your program as described above.
3) Press the audio button until its LED lights, indicating the audio mode is active.
4) Use the Audio level slider to adjust the music sensitivity.
5) To return to normal mode, press the audio button a second time causing its LED to go out; the audio mode is now
disengaged.
RUNNING A PROGAM WITH THE SPEED SLIDER
1) Make sure the audio mode is disengaged (Audio LED goes out).
2) Select your program as described above.
3) Move the speed slider to the SHOW MODE position (the button), then press the flash button (25-48) while
pressing and holding down the rec speed button, the corresponding program will not run with standard beat any
longer.
4) Now move the speed slider to select your desired speed.
NOTE: Step 3 is not necessary if the selected program is not recorded with standard beat.
RUNNING A PROGRAM WITH STANDARD BEAT
1) Make sure the audio mode is disengaged. Press the mode select button to select CHNS◄►SCENE mode.
2) Press the park button to select the mix chase mode; the LED will light indicating your selection.
3) Select your program as described above.
4) Move the speed slider until the segment display shows your desired value. Press the tap sync
button twice to define the beat time.
5) While pressing and holding down the rec speed button, press the flash button (25-48) that stores the program.
6) The program will run with the set time or beat when engaged.
7) Repeat steps 4 and 5 to set a new beat time.
CHANGING THE SPEED MODE BETWEEN 5 AND 10 MINUTES
1) Press and hold the record button.
2) Press flash button 5 or 10 three times while holding down the record button.
3) The 5 MIN or 10 MIN LED should light up indicating the speed slider is set to run in the 5 or 10 minute mode.
d) MIDI
MIDI-IN MODE
• Hold the RECORD button.
• Press flash button 1 three times in PRESET A.
• Release the RECORD button.