Velleman HAA2866 User Manual
Page 14
6) Record an “EM Card + Commom User Code” to Operate The Output 1 for Door Open
10
4
004 #
(a) (b) (c) (d) (e)
(a)
(b)
(c)
(d)
(e)
(f )
REMARK:
If more User PINs and Cards are required for Output 1, repeat the procedures (3) , (4) , (5) or (6)
above with other User IDs, such as 005, 006, 007 --- 999 etc. Total 1,000 users are allowed. See
Programming Location 10 for the details.
7) Close The Programming Mode
---- 2 beeps
The programming mode is closed. The keypad is back to normal operation mode
OPERATION
8) Open The Door with The EM CARD
---- 2 beeps, the door is open
9) Open The Door with The User PIN
8321
#
---- 2 beeps, the door is open
10) Open The Door with The EM CARD + User PIN
6123
#
---- 2 beeps, the door is open
11) Open The Door with The EM CARD + Common User Code
8625
#
---- 2 beeps, the door is open
REMARK:
In the next Section, “KEY IN AND STORE THE DESIRED VALUES” describes all the features and
functions of the system in detail. Users can follow them to tailor the desired values for their access
control systems. Suggest the general users also spend some time on them to get acquaint with this
powerful system for future expansion.
READ CARD
READ CARD
READ CARD
**
13
READ CARD
10 = Programming Location for Output 1
4 = Programming option for EM Card + Common User Code
004 = One of the 1,000 User IDs for the User PIN/Card from 000-999
Read Card = Put the Card close to the card reader
# = Confirm the card is read, 2 beeps, the Common User Code goes to this User ID
automatically
A Common User Code (for example: 8 6 2 5) MUST be set at the Programming Location 03
first for this operation mode. The code can be used for all the EM Cards in this operation mode.