TC Electronic FireworX - Manual (Page 66)

64
THE BLOCKS
Dual Three Tap
The Dual Three Tap Delay is capable of performing three
delay taps on each of the two delay lines. The delay time is
shared between the two delay lines, e.g. if Delay line 1 is
using 500 ms Delay line 2 will have 850 ms available. The
two delay lines have their own Input level, which basically
means that they perform much like two individual delay
processors. The parameters available in the Modifier Matrix
are marked with an asterisk*.
DUAL THREE -TAP
Delay Line 1&2
Time 1-2-3
Sets the delay time of the two taps on Delay line 1.
Maximum delay time per tap is 1350 ms.
Tempo
The Tempo parameter sets the relationship to the global
Tempo e.g. if you set it to 1/4T the Delay will use quarter
note triplet of the tapped tempo to perform one cycle.
1/4 equals the BPM (tapped Tempo).
The subdivisions available are, 16/1 (16 bars for performing
one period), 8/1, 4/1, 2/1, 1/1, and 1/2-1/32 in straight, dotted
and triplet notes - 1/4 equals BPM (beats per minute).
If you select “Ignored” the current parameter will use the
Preset value and will not be affected by the Global Tempo.
Feedback 1-2-3*
Sets the amount of feedback on Tap 1 and 2.
NOTE: The sum of the two feedbacks is limited to 100%.
Levels 1-2-3*
Sets the level of each of the two taps.
Pan Position 1-2-3*
Controls the panning of the two Delay taps.
Lowcut 1-2-3*
Cuts off frequencies lower than the selected frequency. The
slope of the filter is 12dB/octave.
Highcut 1-2-3*
Cuts off frequencies higher than the selected frequency. So if
you feel that there is too much treble in your signal, you can
remove it by adjusting the highcut filter down. The slope of
the filter is 12dB/octave.
Line Level 1-2*
Adjusts the input level of the two Delay lines. This enables
you to lower the level of one of the two lines without
affecting the second. The Line level is a percentage
adjustment of the algorithm In Level.
Mix*
Mixes between direct sound and effect.
In Level*
Controls the input level of the block.
Out Level*
Controls the output level of the Delay block.
One Tap
The One Tap is a mono in, mono out sub-algorithm.
The parameters available in the Modifier Matrix are marked
with an asterisk*.
ONE TAP
Time
Sets the delay time. Maximum delay time is 1350 ms.
Tempo
The Tempo parameter sets the relationship to the global
Tempo e.g. if you set it to 1/4T the Delay will use quarter
note triplet of the tapped tempo to perform one cycle.
1/4 equals the BPM (tapped Tempo).
The subdivisions available are, 16/1 (16 bars for performing
one period), 8/1, 4/1, 2/1, 1/1, and 1/2-1/32 in straight, dotted
and triplet notes - 1/4 equals BPM (beats per minute).
If you select “Ignored” the current parameter will use the
Preset value and will not be affected by the Global Tempo.
Feedback*
Adjusts the amount of Feedback.
Pan Position*
Controls the panning of the Delay.