TC Electronic FireworX - Manual (Page 71)

69
THE BLOCKS
and triplet notes - 1/4 equals BPM (beats per minute).
If you select “Ignored” the current parameter will use the
Preset value and will not be affected by the Global Tempo.
Depth*
Will set the intensity of the Tremolo, i.e. how deep it sweeps.
Curve (Only in Advanced)
Sets the curve of the LFO. Choose between: Square, Sine, or
Triangle.
The most common LFO curve in Tremolo is Triangle.
Use the Square waveform with 100% Depth to get
holes in your sound (called Transforming).
Pulsewidth* (only in Advanced)
Controls the division of the upper and lower part of the
current waveform, e.g. if Pulsewidth is set to 75%, the upper
half of the waveform will be on for 75% of the time.
LFO Phase (only in Advanced)
An LFO phase change causes a small delay in one of the
waveform starting points. This means that left and right
outputs start the current waveform at two different points.
Example: If LFO phase is set 180º, the left and right will be
exactly opposite.
Mix*
Mixes between direct sound and effect.
In Level*
Controls the input level of the block.
Out Level*
Controls the output level of the block.
Pulsewidth
Square
Triangle
Sine
Simple/Surround Panner
The Panner changes the level of the source signal opposite in
left/right according to the LFO curve, depth and speed. The
Surround Panner is capable of panning beyond normal stereo
image by changing the phase of the signal while panning.
The parameters available in the Modifier Matrix are marked
with an asterisk*.
PAN+TREMOLO
Mod Link (Only in Simple Panner)
Enables you to bypass the internal LFO of the Panner, and
control the sweep manually through the Modifier Matrix.
When set to “Shape” the Speed entrance in the Modifier
Matrix works as manual control over the Panner. “Speed” lets
the Panner’s internal LFO handle the modulation.
Speed*
Controls the speed of the Panner. The simple Panner always
pans fully Left and Right.
Tempo
The Tempo parameter sets the relationship to the global
Tempo e.g. if you set it to 1/4T the Panner will use quarter
note triplet of the tapped tempo to perform one cycle.
1/4 equals the BPM (tapped Tempo).
The subdivisions available are, 16/1 (16 bars for performing
one period), 8/1, 4/1, 2/1, 1/1, and 1/2-1/32 in straight, dotted
and triplet notes - 1/4 equals BPM (beats per minute).
If you select “Ignored” the current parameter will use the
Preset value and will not be affected by the Global Tempo.
Curve (Only in Surround)
Sets the curve of the LFO. Choose between: Square, Sine, or
Triangle.
The most commonly used curve in Panning is Sine.
Pulsewidth* (Only in Surround Panner)
Controls the division of the Left and Right part of the current
waveform, i.e. if Pulsewidth is set to 75%, Left channel will
be on for 75% of the time. (See Pulsewidth figure above).
LFO Phase (Only in Surround Panner)
An LFO phase change causes a small delay in one of the
waveform starting points. This means that Left and Right
outputs start the current waveform at two different points.