PowerWalker ViewPower PowerWalker User Manual
Page 25
24
software, please login first and modify the password. The default password is
“administrator” at first log in. Users can only browse UPS status and information as
Guest status without login as an Administrator. Guest can NOT control or executive any
setting.
Modify password
Step 1
Select ViewPower Configuration>>Password. Refer to Diagram 5-1.
Diagram 5-1
Step 2
Enter old password, new password, and retype new password in confirm
password column to modify password for administrator. (The password should
be at least 6 digits) Then click “Apply” button to successfully modify password
for administrator.
NOTE1: Simply click “Login” button on the top right corner to log in the software.
NOTE2: If password is forgotten, it’s necessary to re-install the software.
5.1.2.
SMS Configuration
It’s for entering SMS receiver list. In the event of an alarm condition occurring, a
message about UPS status will be sent to the specified users via mobile phone. For the
event receiving list, please configure in “Event Action” column (refer to section 5-1-4).
Step 1
Choose ViewPower Configuration >> SMS. Refer to Diagram 5-2.