PowerWalker ViewPower PowerWalker - Manual (Page 37)

36
Step 3 Add/Delete remote system IP address.
Step 4 Click “Apply” button to save all data.
NOTE: Click “Default” button to recover the default setting.
Conditions:
When the UPS is running from battery, shut down the remote systems after xx
min xx sec: When clicking the checkbox, remote systems which are powered by
monitored UPS will shut down after monitored UPS running on battery mode for
xx min xx sec. The maximum setting number for minutes is 999, and for
seconds is 59.
Remote shutdown when the capacity of battery down to xx % (Battery mode):
When clicking this checkbox, local UPS will still operate until the battery capacity
is down to xx%. Until then, it will remotely shut down PCs.
Immediately shut down the following remote systems when the battery is
running low: When clicking the checkbox, remote systems which are powered
by monitored UPS will shut down when monitored UPS is at low battery level.
5.2.3. Parameter Setting
Some UPS functions can be set and changed via software. Parameter setting includes
backup time setting for P1, battery number setting, voltage and frequency range
setting for bypass mode, and voltage range setting for ECO mode.
Step 1 Select UPS Setting >> Parameter Setting. Refer to Diagram 5-13.