Dexter Laundry T-1450 EXPRESS (30-Cycle) - Manual (Page 10)

10
OPERATING INSTRUCTIONS
1. Ensure that power is turned on to the washer.
2. Ensure that the ADVANCE/RUN/PROGRAM key lock is in the RUN position.
3. Load the clothes loosely in the cylinder, and latch the door securely.
Be sure clothing does not get caught between the door gasket and tub
front when closing the door.
NOTE: To begin closing the door, the handle must be in the horizontal
position. After moving the door to the closed position, the handle
must be turned down to the vertical position, in order to latch the
door for machine operation.
4. Select one of thirty cycles by using the SCROLL UP/SCROLL DOWN buttons to
change the number indicated in the two digit LED display. The selection
is made when the number indicated corresponds with the desired cycle.
5. If you are manually adding wash compounds, add low sudsing powdered
detergent, in the amount shown below, into the detergent compartment on
top of the machine. Location is illustrated on the black cover on the
top of the machine. This compartment will be flushed during the WASH
segment of the cycle. Rinse conditioners may be added to their own
compartment, if desired. This compartment will be flushed during the
FINAL RINSE segment of the cycle.
POWERED
DETERGENT REQUIREMENT
T1450 1/2 CUP
Figure 8 - Recommended Detergent Quantity
6. If you wish to manually add bleach during the cycle, add bleach in the
round opening in the top of the machine. Location is illustrated on the
black cover on the top of the machine.
NOTE: Any additional washing compounds may be added at the appropriate
time by pouring into the round opening in the top.
7. Push the green START button to start the cycle.
The cycle time remaining is displayed throughout the cycle. The cycle
number in operation can be displayed by pushing and holding START, then
push SCROLL UP. The cycle number will be displayed as long as these two
buttons are depressed. The actual bath temperature can be displayed by
simultaneously pushing the start
and scroll down button.
Soak - At any time during the cycle, the red STOP button can be depressed
to stop the washer. All washer cycle information is retained, and the
door remains locked. The washer will soak the load for 15 minutes, then
agitate for 30 seconds. This will repeat until the cycle is started
again. This feature allows for an extended soak if required. The washer
cycle will continue when the START button is depressed.
The selected cycle can be cleared at any time by depressing and holding
the STOP button for a minimum of three seconds.