Dexter Laundry T-1450 EXPRESS (30-Cycle) - Manual (Page 17)

17
Notes:
 The cycle cannot be advanced during the “open drain” step of the bathes.
 The cycle cannot be advanced when the hot and cold water valves to the tub
are on after advancing during or after a chemical injection.
 The cycle cannot be advanced again while the hot and cold water valves to the
tub are on after advancing when the water temperature was 65 to 90.
 The Rapid Advance mode may only be entered after a cycle is started.
 The indicator lights will show to which segment the cycle has been advanced.
 The Rapid Advance mode cannot skip the final three tumbles of the cycle. The
door lock may remain activated for a couple minutes after the cycle has been
completed.
 The chemical injection signals will not turn on if the Rapid Advance mode is
entered before the injection.
To end the cycle without waiting for the time to count down, push and hold the
“STOP” button for 5 seconds or more. The display will then show the cycle
number and be ready to start the cycle.