SENA PS400 - Manual (Page 11)

11
2: Getting Started
This chapter describes how to set up and configure the HelloDevice Pro Series in the first place.
- 2.1 Panel Layout explains the layout of the panel and LED indicators.
- 2.2 Connecting the Hardware describes how to connect the power, the network, and the serial
device to the HelloDevice Pro Series.
- 2.3 Accessing Console Port describes how to access the console port using a serial console at a
local site or telnet console at a remote site.
Following items are pre-required to get started.
- One DC power adapter (included in the package).
- One serial data cable for configuration and for connecting the RS-232 serial device.
- One PC with Network Interface Card (hereafter, NIC) and/or one RS232 serial port.
- Terminal emulation program running on the PC
- One Ethernet cable
2.1 Panel Layout
2.1.1 PS100 Panel Layout
The PS100 has five LED indicator lamps for status display as shown in Figure 2-1. Two lamps on the
upper side indicate statuses of 10 Base-T Ethernet Link and Act. Next lamp indicates statuses of
receive and transmit of the serial port for data communication. Next two lamps indicate the system
running status and the system power-on status. Table 2-1 describes function of each LED indicator
lamp.