SENA PS400 - Manual (Page 55)

55
F/W REV. : V1.00 MAC Address : 00-01-95-04-04-33
Cur Status : Running Current time : 2038/05/10 04:34:10
---------------------------------------------------------------------------
IP information
---------------------------------------------------------------------------
IP Mode : Static IP Expiration : N/A
IP Address : 192.168.2.100 Subnetmask : 255.255.0.0
Gateway : 192.168.1.1 Receive/Transmit errors : N/A
Primary DNS : 211.172.129.198 Secondary DNS : 211.172.129.199
------------- --------------------------------------------------------------
Port #0 information
---------------------------------------------------------------------------
Connection Mode : Modem Emul Local port : 6000
Destination : 192.168.1.120:6010 Host allowed : 0.0.0.0/0.0.0.0
Incoming bytes : 268492 Outgoing bytes : 285121
UART : 9600-N-8-1-Hardware Encryption : 3DES
Inactivity timeout : 300 sec Inter-character timeout : 100 ms
...
---------------------------------------------------------------------------
Port #3 information
---------------------------------------------------------------------------
Connection Mode : TCP Server Local port : 6003
Destination : 192.168.1.120:6013 Host allowed : 0.0.0.0/0.0.0.0
Incoming bytes : 0 Outgoing bytes : 0
UART : 9600-N-8-1-Hardware Encryption : None
Inactivity timeout : 100 sec Inter-character timeout : 1 ms
End of Status
Press Enter
Figure 6-2. System status display (PS400)
6.2 Display log data
Users can see the system log by selecting submenu 2.Display log. Users can also clear current
log data by selecting submenu 4.Clear log.
2002-02-10 04:41:32 > ### No valid log table. Initialize logs ###
2002-02-10 04:41:44 > ### Boot up System Start ###
2002-02-10 04:41:44 > ### Start with Static IP by 192.168.2.100 ###
End of Log
Press Enter
Figure 6-3. System log display
6.3 Automatic log delivery by email
The HelloDevice Pro Series can be configured to send log data automatically if the number of log
messages unsent reaches the pre-defined number. Users can enable this feature by selecting
submenu 5.Send log by email. If this feature is enabled, you have to configure email related