SENA PS400 - Manual (Page 15)

15
2.2 Connecting the Hardware
This section describes how to connect the HelloDevice Pro Series to serial devices for the first time
test.
- Connect the power to the HelloDevice Pro Series
- Connect the Ethernet cable between the HelloDevice Pro Series and Ethernet hub or switch
- Connect the serial data cable between the HelloDevice Pro Series and serial device(s)
2.2.1 Connecting the power
Connect the power jack to the HelloDevice Pro Series power jack using DC power adapter included in
the package. If the power is properly supplied, the [Power] lamp will maintain solid red.
(a) Connecting the power to the PS100 (b) Connecting the power to the PS200/400
Figure 2-4. Connecting the power to the HelloDevice Pro Series
2.2.2 Connecting to the network
Connect the one end of the Ethernet cable to the HelloDevice Pro Series 10Base-T port and the other
to the Ethernet network. If the cable is properly hooked up, the HelloDevice Pro Series will have a
valid connection to the Ethernet network by indicating:
- [Link] lamp maintains solid green
- [Act] lamp continuously blinks to indicate the incoming/outgoing Ethernet packets
If any of the above does not happen, the HelloDevice Pro Series is not properly connected to the
Ethernet network.