SENA PS400 - Manual (Page 21)

21
3: IP Address Configuration
A valid IP address of the HelloDevice Pro Series needs to be assigned before it starts to work in the
user's network environment. A network system administrator may provide the user with this IP
address setting information for the network. The IP address must be unique within the network.
Otherwise, the HelloDevice Pro Series will not have a valid connection to the network.
Users can choose the desired IP mode out of the three IP operating modes, i.e., Static IP, DHCP, and
PPPoE, on the IP Configuration Screen of console interface. The factory default IP mode is DHCP
mode. Table 3-1 shows the parameter items for IP Configuration menu.
Table 3-1. Hierarchical view of the IP Configuration menu items
IP mode
IP address
Subnet mask
Default gateway Static IP
Primary DNS/ Secondary DNS
DHCP IP mode
IP mode
PPPoE
PPPoE User name/ Password
3.1 Static IP
3.1.1 Overview
In the Static IP mode, users have to manually specify all the parameters such as IP addresses of the
HelloDevice Pro Series, the gateway computer and the domain name server computers, and the
network subnet mask. The HelloDevice Pro Series tries to locate such information whenever it boots
up.
The user interface for Static IP configuration is shown below in Figure 3-1. Users can select menu by
typing the menu number and then pressing [ENTER] key.
----------------------------------------------------
IP configuration
----------------------------------------------------
Select menu:
1. IP mode: static IP
2. IP address: 192.168.1.1
3. Subnet mask: 255.255.255.0
4. Default gateway: 192.168.1.254
5. Primary DNS: 210.106.255.188
6. Secondary DNS: 210.106.255.189
<ESC> Back, <ENTER> Refresh
--- >
Figure 3-1. Static IP configuration screen