SENA Parani-BCD110-210 - Manual (Page 16)

16
Example of remote configuration mode.
3.6. Software and Utility
This configuration software and utility for firmware update is included with the product, which also can
be downloaded from
http://www.sena.com
Table 3-3 Configuration Software
Software Purpose Operating System
ParaniWIN Configuration MS Windows 98SE or Higher
ParaniWizard Pairing Configuration MS Windows 98SE or Higher
ParaniMultiWizard Multi Configuration MS Windows 98SE or Higher
ParaniUpdater Firmware Update MS Windows 98SE or Higher
3.7. ParaniWIN
ParaniWIN is a program that runs on Microsoft Windows for the configuration of Parani-BCDx10.
Install ParaniWIN on your computer. Connect the serial port of Parani-BCDx10 into the serial port of
the computer and turn on the power.(BCD Development Board or RS232 interface board may be
required to access the serial port of Parani-BCDx10.) Run ParaniWIN.
Figure 3-1 Serial Port Setting
Set each option properly and click [Confirm]. If the settings of the Parani-BCDx10 are different from
the ParaniWin, an error message will pop up. If the Parani-BCDx10 is in the status of connection,
warning message will pop up. Then the current connection can be cancelled by [Disconnect] button on
the main window.
CONNECT 000195000001
+++
Please Enter Password
AT+PASS=0000
Remote Configuration Enabled
AT+BTINFO?
000195000001,BCDx10v2.0.6-095515,MODE0,CONNECT,0,0,HWFC