SENA Parani-BCD110-210 - Manual (Page 19)

19
Parani-BCDx10 supports two security options, Authentication and Encryption. If you enable the
Authentication option, you must also enter a Pin Code value. If the authentication is enabled, the
connection, between the Master and Slave device must share the same Pin Code. In case that Parani-
BCDx10 connects to another Bluetooth device, that requires authentication, you must know the other
device’s Pin Code. In general, most Bluetooth devices have a pincode of 1234 or 0000. If you check
Encryption option, the Parani-BCDx10 will encrypt packets and sent to the device. The Encryption
options works well in case that only one of the devices between Master and Slave use the Encryption
option.
Parani-BCDx10 has 4 response messages, ‘OK’, ‘ERROR’, ‘CONNECT’, and ‘DISCONNECT’. In
some cases, these responses can affect the host system unexpectedly. To prevent this, user can set
the Command response to ON or OFF.
Click [Apply] button to apply any changes made to the Parani-BCDx10.
Connection(out) icon will show the following window to search and connect other Bluetooth devices.
Figure 3-6 Connection(out) Window
Click [Search] button to search nearby Bluetooth devices. Once several Bluetooth devices has been
found, select one of the devices and click the [Connect] button. The selected Bluetooth device must be
discoverable and connectable. Click [Disconnect] button to cancel the connection.
After the connection has been established, you will be able to test signal strength by pushing the
START button.