SENA Parani-BCD110-210 - Manual (Page 22)

22
configuration should be completed. Make sure that each Parani-BCDx10’s connect LED is on. At
this point, when both Parani-BCDx10s are restarted the connection will be established automatically.
3.8. ParaniWizard
ParaniWizard is a Wizard program that will allow you to configure a pair of Parani-BCDx10s for an
automatic connection. To make connection with Bluetooth devices other than Parani-BCDx10, use
ParaniWIN or AT commands on a terminal program.
In this example, we will refer to the two Parani-BCDx10s as BCD1 and BCD2 respectively.
Install and run ParaniWizard.
Figure 3-10 ParaniWizard Step 1
Plug BCD1 into the serial port of the host computer and power on the unit. Click [Wizard Setting]
button to configure the serial port settings of BCD1. These settings must be the same as those of the
host system, to which BCD1 will be used. Click [Next].
Figure 3-11 ParaniWizard Step 2